What happens if you drop a vape in water?

You probably take your vape everywhere. It's possible that your vape will drop in water at times. It happens to everyone, so don't be embarrassed if it does happen to you.Dropping a vape into water can cause it to explode. Water and wires are not compatible. It is very likely that a vape will die if it is dropped in water. There may be some cases where the device can be reactivated after being submerged in water. We'll be sharing some tips to help you revive your vape rather than throwing it out. Innokin has created some water-resistant vapes which can be used to prevent water-related accidents.

What happens if you drop a vape in water?

Dropping a vape into water is a bad idea. You should immediately remove it from water. If the device does not have any protections against water ingress, moisture can quickly flood its interior.Two ways water can permanently damage electronic devices and vapes is how it affects them.

1. Water impurities can conduct electricity and cause a short circuit. Although pure water isn't an excellent conductor, almost all water contains impurities like dissolved minerals. The likelihood of a short circuit being a problem is high so you should not use a vaping device you have just dropped into water. This could cause the device to become permanently inoperable.
2. The internal metal parts of cheap disposable vapes in Cyprus devices can also corrode from water. Corrosion is a more long-term problem than a short circuit and may not have an immediate impact on the device's performance. Your device could start to display strange behavior or stop functioning altogether after a few weeks or months.

These are the two main things to remember when dropping a vape in water.

1. To prevent water ingress, you must immediately remove the device from water. You will be able to remove the device from the water immediately, so that the water doesn't have time to contaminate its internal electronics.
2. Do not attempt to use the device as it could cause a short circuit. To encourage airflow, remove the removable battery from the device.
3. As much water as possible from the exterior and interior of the device. This will be discussed in more detail later.

A water-resistant vape can handle all the little accidents in life

Did you know some vape kit can withstand water? The Innokin Adept Zlide kit is IP67 compliant for ingress protection. This means it can be immersed in water up to one meter for up to 30 mins. Innokin Adept vape mode is impervious to dust and offers some of the most comprehensive protection against the elements you will ever find. The Adept mod can be pulled out of water even if it is submerged completely.We mentioned at the beginning that it is difficult to avoid an accident with your vaping device. You won't have any worries about these accidents if your device is protected from the elements. Instead, you can enjoy vaping and just concentrate on the fun of it.

How to fix a vape after it has been dropped in water

So, you've just dropped your vaping device in water. What do you do now? You should prevent a short circuit, as we have already mentioned. The device should be removed from the water immediately. You should remove any removable batteries from the device and place them aside. Keep the battery cover on.You should also take out the removable tank or pod from any device you are using. You can wash the component in clean water, and then dry it by placing it on a rack to dry. A vape tank or pod does not have any electronic components so there is no need to worry about a short circuit. You should also disassemble your vape as much as possible to allow air to flow through it.Next, you should remove all of the components from your vape. To remove water from the device's surface, use paper towels. After removing the pod, dry the chamber at its top. Dry the battery compartment if you have a vape pen with a removable battery.To remove water from disposable vapes, blow through the device. This will force water out of its air intake hole. While holding a piece of paper over the intake hole, blow firmly through it. You can remove any water from the device by placing a paper towel over it.